Latest news

Double shaft for anchoring in concrete with steel peg

Fixed double-shaft basis for customised arrangement of panels by anchoring in concrete with a standard-length 1m hot-galvanized steel peg. Peg penetration depth 80cm. No geological study is required. Anodising or powder coating option for installations in an alkaline environment.

  • IMGP0411

  • IMGP0413

  • IMGP0421

  • IMGP0422

When choosing to anchor the double-shaft basis by anchoring in concrete, the length of the steel peg is standard and thus no geological study is required if of course there are no particular geologic anomalies.

The peg is hot-galvanized at 5mm (86micra and its type is S235). The stand of the aluminium base hooks into the peg with a cross-section (U) by 15cm. It is supported with a M10X85 stainless steel screw. An aluminium film or EPDM rubber must be placed between the 2 materials to prevent corrosion by oxidation over time.

The base dimensions vary depending on the arrangement of the panels. The standard dimensions are for 2 to 3 vertical panels (portrait) or 3 to 5 horizontal panels (landscape) for usual panel dimensions of 166x99cm while the standard tilt dimensions are 5-10-15-20-25-28-30 degrees. The usual panel-ground distance is 45cm.

Special structures are possible for panel layouts other than those mentioned above, which will be studied based on the layout plan you send us regarding their statics and feasibility of construction.

  • TECHNICAL INSTRUCTION - DOUBLE-SHAFT BASE FOR ANCHORING IN CONCRETE WITH STEEL PEG
  • INFORMATION - STEEL PEG CODE A1837

Contact

Sales Department
Tel: +30.22950.98840-2
Fax: +30.22950.98839
E-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

Factory & Exhibition
42nd km Nat.Road Athinon-Lamias, GR-19011 Avlonas Attica, Greece (map)
E-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

Newsletter

Subscribe to our newsletter