Latest news

Double shaft for anchoring with steel peg

Fixed double-shaft base for customised arrangement of panels by anchoring with a standard-length hot-galvanized steel peg following a static/geological study to determine the required penetration depth depending on the quality of the soil. Anodising or powder coating option for installations in an alkaline environment.

In the event of anchoring, you should inform us of the peg penetration depth, for the purposes of the statics of the base support, as arising from the pull-out test and the geological study and for the raising of the panel from the ground (standardised 45-50cm), to obtain the total length of the peg (standardised - peg 25cm above ground)

The peg is hot-galvanized at 5mm (86micra and its type is S235). The stand of the aluminium base hooks into the peg with a cross-section (U) by 15cm. It is supported with a M10X85 stainless steel screw. An aluminium film or EPDM rubber must be placed between the 2 materials to prevent corrosion by oxidation over time.

The base dimensions vary depending on the arrangement of the panels. The standard dimensions are for 2 to 3 vertical panels (portrait) or 3 to 5 horizontal panels (landscape) while the standard tilt dimensions are 5-10-15-20-25-28-30 degrees.

Special structures are possible for panel layouts other than those mentioned above, which will be studied based on the layout plan you send us regarding their statics and feasibility of construction.

  • TECHNICAL INSTRUCTION - DOUBLE-SHAFT BASE FOR ANCHORING WITH STEEL PEG
  • INFORMATION - STEEL PEG CODE A1837

Contact

Sales Department
Tel: +30.22950.98840-2
Fax: +30.22950.98839
E-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

Factory & Exhibition
42nd km Nat.Road Athinon-Lamias, GR-19011 Avlonas Attica, Greece (map)
E-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

Newsletter

Subscribe to our newsletter