Latest news

Double-shaft base for concrete blocks

Fixed double shaft base for customised panel layouts on concrete blocks which you can build along or perpendicularly to the trapezium. The bases are supported on the block by anchoring the stand with a tie of your choice, while the specification of the block requires an engineering study. Anodising or powder coating option for installations in an alkaline environment.

  • 0574641

  • 125

  • 126

  • 127

  • 128

  • 129

For the double-shaft bases, you can anchor the stand of the base with a tie to the concrete block you will create. The company does not supply concrete blocks, and it is the responsibility of the installer to construct them depending on the resulting expansion of the base and the reactive forces on the block.

The blocks can be constructed either along or perpendicularly to the row, or with 2 separate elements (weights) for the front and back stand of the base. The study on the size and dimensions of the block should be undertaken by an engineer based on the type of the base, the wind pressure in the region and the category of the soil zone.

Indicatively, for concrete blocks perpendicularly to the base for a typical double-shaft base in layouts with 2 vertical frames (portrait) with standard panel dimensions 166x99cm and a local wind pressure of approximately 160kg/m2, the block dimensions would be: height 30cm (15cm in the soil), width 60cm & length 340cm. You can find the reactive forces at the stand of the base in the attached .pdf file.

The dimensions of the bases and the reactive forces vary depending on the layout of the panels. The standard dimensions are for 2 to 3 vertical panels (portrait) or 3 to 5 horizontal panels (landscape) while the standard tilt dimensions are 5-10-15-20-25-28-30 degrees.

Special structures are possible for panel layouts other than those mentioned above, which will be studied based on the layout plan you send us regarding their statics and feasibility of construction for the supply of materials.

  • TECHNICAL INSTRUCTION - DOUBLE-SHAFT BASE FOR CONCRETE BLOCK
  • SPECIFICATIONS - STAND FOR DOUBLE-SHAFT BASE, DOUBLE-SHAFT BASE WITH VERTICAL 166X99CM PANEL LAYOUT.
  • INFORMATION - REACTIVE FORCES AT THE BASE STAND

Contact

Sales Department
Tel: +30.22950.98840-2
Fax: +30.22950.98839
E-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

Factory & Exhibition
42nd km Nat.Road Athinon-Lamias, GR-19011 Avlonas Attica, Greece (map)
E-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.

Newsletter

Subscribe to our newsletter